Available Now

Aster LNER/BR A3 Tender Coupling Pin

This modification consists of a new Brass pin which operates from below the tender, the original coupling pin can no longer be seen on the tender footplate, the original spring is utilized with the new pin, no modification's are required to your original Aster parts.

Note:- A small drop of threadlocking compound is required for fitting.

Price: £10 inc p&p (UK)
Hi-Res Cab Picture

IN STOCK

Aster LNER\BR A3 Large Bore Water Connector

The new pipe connector is a re-design of the Aster standard connector which takes the inside diameter to almost twice that of the standard connector allowing the axle pump to maintain the water level in the boiler, this is supplied with a matching nut which is a great visual improvement over the standard Aster thumb wheel.

£10 per set including p&p (UK)

IN STOCK

Aster LNER/BR A3 Regulator Extension Shaft (Mk2)

This extension shaft allows regulator control with the rear cab roof in place, cnc turned from Aircraft grade S150 (non magnetic) Stainless Steel, the shaft fits over the regulator stub & uses the existing regulator handle, supplied with Allen Key & fitting instructions.

£10 Each including p&p (UK)

OUT OF STOCK

Double Chimney Blanking Plug

A CNC turned & milled sold Brass (CZ121) double chimney blanking plug for the Aster BR A3 locomotives, this plug is used with the Aster steam raising blower to block off the second chimney until steam is raised, complete with 1/8" dia retaining hole.


Price: £n/a inc p&p (UK)

 

LNER/BR A3 burner height modification

This modification removes at least 2mm from the base of the Aster A3 standard burner unit, new CNC machined bungs are silver soldered into the height adjusted wick pots, the burner is then grit blasted, etched and spray painted semi-matt black (satin)

Note: This mod requires your burner to be posted to MLW.

£20 Each including p&p (UK)